4 – 2
Before you start cutting, it is important that you become familiar with the types and features of the cutter
blades which can be used with the cutting plotter. By selecting the optimum combination of cutter blade
and film, you can achieve higher cutting quality.
CAUTION
To avoid cutting your fingers, always handle the cutter blade with caution.
4.1 Types and Features of Cutter Blades
Part no. Blade diameter Compatible
Features
and material and offset plunger
CB09UA 0.9-mm diameter PHP32-CB09N The standard blade for cutting color
(Supersteel) 0.45 mm offset adhesive-backed film.
Suitable for cutting film with a thickness
under 0.25 mm.
Max. cutting distance: approx. 4,000 m.
CB15U 1.5-mm diameter PHP32-CB15N Capable of cutting thicker film than possible
(Supersteel) 0.75 mm offset with the CB09UA blade.
Suitable for cutting film with a thickness of
0.25 mm to 0.5 mm.
4.2 Replacing the Cutter Blade and Adjusting Its Length
The cutting plotter performs cutting using a cutter blade that is mounted in a cutter pen plunger. The
cutter pen plungers come in two diameters to suit the cutter blade to be mounted (the 0.9-mm cutter
pen plunger comes standard). Be sure to mount the cutter blade in its corresponding cutter pen plunger.
CAUTION
To avoid cutting your fingers, always handle the cutter blade with caution.
Structure of the Cutter Pen Plunger
PlungerCutter blade
Plunger cap Blade length adjustment knob
(blue : for 0.9-mm diameter blades)
(red : for 1.5-mm diameter blades)
To Next Page
Loading...
