3 – 3
3.2 Turning on the Power
Step 1
Check that the Power switch is turned off (its “
O
”
side is down).
Step 2
Connect the female plug of the power cord pro-
vided to the cutting plotter’s AC power inlet and
connect its male plug to an electrical socket. Be
sure to ground the cutting plotter.
Step 3
Turn on the cutting plotter by pressing the “|” side
of its Power switch (the control panel’s POWER
lamp lights).
Step 4
If no medium has been loaded, the message below appears to prompt you to load a medium.
LOAD MEDIA!
If a medium has been loaded, the menu below appears for selecting the media mode.
ROLL 1
ROLL 2
For instructions on loading a medium and selecting the media mode, see Section 3.3, “Loading the
Medium.”
To Next Page
Loading...
