7 – 3
7.2 Specifying the OFFSET FORCE
Because the direction which the cutter blade’s tip is facing cannot be confirmed during the cutting
plotter’s initialization routine, “initial blade control” is required to properly orient the blade’s tip. This
function specifies the cutting force to be applied during initial blade control. Particularly when cutting
thick film, the OFFSET FORCE setting is used to control the rotation of the blade’s tip during initial
blade control. The OFFSET FORCE need not be specified for film of regular thickness.
Step 1
Press the
PAUSE
key to enter PAUSE mode.
Step 2
Press the
NEXT PAGE
key until the menu below appears.
INTERFACE
PEN UP/DOWN
Step 3
Simultaneously press the
and
NEXT PAGE
keys to display the menu below.
PEN UP SPEED
OFFSET FORCE
Step 4
Press the
F2/TEST
key (OFFSET FORCE) to display the menu below.
OFFSET FORCE
4
Use the and keys to select the desired OFFSET FORCE and then press the
ENTER
key to
register your setting.
The OFFSET FORCE can be set in a range of 1 to 31 for the CE2000-60, and 1 to 39 for the CE2000-
120.
Step 5
Press the
PAUSE
key to cancel the PAUSE mode.
NOTE : The OFFSET FORCE setting is retained in the cutting plotter’s internal memory, even
while the cutting plotter is turned off.
To Next Page
Loading...
