9
9
TROUBLESHOOTING PROCEDURES
9.1 Printing a List of the Currently Selected Conditions... 9-2
9.2 Running a SELF TEST ............................................................ 9-4
9.3 Using the DUMP Mode ........................................................... 9-5
9.4 Cutting the Demo Pattern ..................................................... 9-7
9.5 The Plotter is Turned On But Doesn’t Operate .......... 9-8
9.6 Mechanical Error Messages and Their Causes .......... 9-8
9.7 Command Error Messages and Their Causes............. 9-9
9.8 The Cutting Results are Unsatisfactory....................... 9-12
To Next Page
Loading...
