GRAPHTEC CE2000-60 - Specifying the Cutting QUALITY

4 – 11
4.4.5 Specifying the Cutting QUALITY
This setting determines the acceleration rate of cutting.
Step 1
After selecting the desired set of cutting conditions, check that the cutting plotter is in READY or PAUSE
status and then press the
F2/TEST
key to display the menu below.
TEST CUT
PEN SETTINGS
Step 2
Press the
F2/TEST
key (PEN SETTINGS) again to display the menu below.
SPEED
PEN FORCE
Step 3
Press the
NEXT PAGE
key to display the menu below.
CUTTER OFFSET
QUALITY
Step 4
CE2000-60
Press the
F2/TEST
key (QUALITY) to display the menu below.
QUALITY
1
At the above menu, use the or key to switch the QUALITY setting between 1 and 2.
CE2000-120
NOTE : • The 2 setting can only be selected when the SPEED setting ranges from 1 through
30 cm/s. When the SPEED setting is 35 cm/s or higher, the QUALITY setting is fixed
to 1 (0.5 G).
• If you change the SPEED setting to 35 cm/s or higher while the QUALITY setting is
2, the QUALITY setting automatically switches to 1 even if you change the SPEED
setting to 30 cm/s or lower.
When the displayed QUALITY value is satisfactory, press the
ENTER
key to register your setting.
When the SPEED setting is “∗∗” (the maximum speed), the QUALITY setting is also displayed as “**” and
automatically assumes a fixed value.
Step 5
Consecutively press the
NEXT PAGE
key until the READY or PAUSE menu reappears.