GRAPHTEC CE2000-60 - Appendix; Main Specifications

A – 2
Item Specifications
Model number CE2000-60 CE2000-120
Configuration Grit-rolling cutting plotter
Drive system Digital servo drive system
Maximum cutting area 584 mm × 50 m 1220 mm × 50 m
Range of guaranteed precision 584 mm × 5 m*
1
1220 mm × 5 m*
1
Compatible media widths Minimum: 50 mm, Minimum: 85 mm,
maximum: 712 mm maximum: 1346 mm
(28 inches) (53 inches)
Maximum media thickness 10 mil (0.25 mm)
Maximum cutting speed 60 cm/s 100 cm/s*
3
Specifiable cutting speeds 1 to 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60 (cm/s)
The CE2000-120 has an additional setting of ∗∗ (100
cm/s).
Cutting force 20 to 300 g/f (31 levels) 20 to 450 g/f (39 levels)
Minimum character matrix About 5 mm for an alphanumeric character (varies
with the medium, font, etc.)
Mechanical step size 0.005 mm
Programmable step size GP-GL: 0.1, 0.05, 0.025, 0.01 mm; HP-GL*
2
: 0.025 mm
Repeatability precision 0.1 mm or less/2 m*
1
No. of mountable pens 1 pen
Compatible cutter type Supersteel blades
Compatible pen type Water-based fiber-tip pens
Compatible cutting media Marking film (polyvinyl, fluorescent, or reflective film)
with a maximum thickness of 0.25 mm (excluding
high-luminosity reflective film)
Standard interfaces RS-232C serial or Centronics-compatible parallel
(automatically selected)
Internal memory capacity 2 Mbytes
Command modes GP-GL and HP-GL (selected at the control panel)
Display panel Liquid crystal display, 16 characters × 2 rows
Power supply
Supply voltage
115 to 230 VAC 50/60 Hz (UL, CSA)
100 to 240 VAC 50/60 Hz (CE)
Power consumption 80 VA 120 VA
Environmental
Operating environment
10° to 35°C, 35% to 75% R.H.
conditions (non-condensing)
Guaranteed precision
16° to 32°C, 35% to 70% R.H.
(non-condensing)
External dimensions 840 (W) × 278 (D)× 250 (H) mm 1489(W) × 656(D) × 1189(H) mm
(including stand)
Weight 13 kg 46 kg (including stand)
*
1
Varies with the type of Graphtec-authorized film and the cutting conditions.
*
2
HP-GL is a registered trademark of Hewlett-Packard Company.
*
3
Only in the diagonal (45° angle) direction.
A.1 Main Specifications