6 – 10
6.7 Specifying the PLOT AREA
This function allows you to specify the area in which cutting will be performed, thus preventing cutting
outside of the specified area. This function lets you make more efficient use of film. When you wish
to cut an uncut portion of film that has already been cut, specify the PLOT AREA to exclude the previously
cut area. Note that when the PLOT AREA is set to specify the cutting area, the origin point is also
repositioned in accordance with the movement of the cutting area.
The previously cut figure
Cutting will only be done in this area
Position of
the L.L. setting
Position of
the U.R. setting
Step 1
Press the
PAUSE
to enter the PAUSE mode.
Step 2
Press the
NEXT PAGE
key until the menu below appears.
FILM
FUNCTIONS
Step 3
Press the
F1/ORIGIN
key (FILM) to display the menu below.
AXIS ADJ.
DIST ADJ.
Step 4
Press the
NEXT PAGE
key to display the menu below.
PAGE LENGTH
PLOT AREA
Step 5
Press the
F2/TEST
key (PLOT AREA) to display the menu below.
DEFAULT L.L.
( 0, 0)
To Next Page
Loading...
