GRAPHTEC CE2000-60 - Feeding the Medium

5 – 5
5.5 Feeding the Medium
When using cutting film, the FEED function advances the film and leaves faint tracks of the grit rollers
on the film to prevent the film from being dislocated while it is being fed during actual cutting.
Step 1
Press the
PAUSE
key to enter the PAUSE mode.
Step 2
Press the
NEXT PAGE
key until the menu below appears.
CLEAR BUFFER
FEED
Step 3
Press the
F2/TEST
key (FEED) to display the menu below.
SHEET FEED
FEED LENGTH 1 m
Use the and keys to specify the desired distance of the FEED operation. The distance can
be specified in a range of 1 m to 50 m.
Step 4
When the desired value is displayed, press the
ENTER
key to initiate the FEED operation (the film is advanced
out of the front of the cutting plotter and then fed back to its original position).
NOTE : If you press the
NEXT PAGE
key while the FEED operation is in progress, the FEED operation
is discontinued at that point and the film is returned to its original position.
CAUTION : When you press the
ENTER
key in Step 4, the FEED operation is immediately initiated.
Before executing the FEED operation, ensure that the front and back areas of the
cutting plotter are free of any obstacles that could obstruct the FEED operation.