7 – 4
7.3 Specifying the OFFSET ANGLE
Based on the coordinate data received, the cutting plotter controls the angle of the cutter blade’s tip
according to the displacement of the travelling angle as defined by the data which specifies the movement
of the cutter pen between coordinate points. This function sets the reference value used for adjusting
the cutter blade’s offset angle. Although a high OFFSET ANGLE setting shortens the overall cutting
time, the cut results may not precisely reproduce the image defined by the data in some cases.
Step 1
Press the
PAUSE
key to enter PAUSE mode.
Step 2
Press the
NEXT PAGE
key until the menu below appears.
INTERFACE
PEN UP/DOWN
Step 3
Simultaneously press the
and
NEXT PAGE
keys to display the menu below.
PEN UP SPEED
OFFSET FORCE
Step 4
Press the
NEXT PAGE
key until the menu below appears.
OFFSET ANGLE
STEP PASS
Step 5
Press the
F1/ORIGIN
key (OFST ANGLE) to display the menu below.
OFFSET ANGLE
30
Use the and keys to select the desired OFFSET ANGLE and then press the
ENTER
key to
register your setting.
The OFFSET ANGLE can be set in a range of 1 to 60.
Step 6
Press the
PAUSE
key to cancel the PAUSE mode.
NOTE : The OFFSET ANGLE setting is retained in the cutting plotter’s internal memory, even
while the cutting plotter is turned off.
To Next Page
Loading...
