9 – 2
9.1 Printing a List of the Currently Selected Conditions
Use this function to print out a list of the cutting plotter's currently selected conditions. A sample printout
is shown on the next page.
Step 1
Mount a plotting pen (not a cutter pen) at the cutting plotter's pen holder and then set the pen type,
FORCE, SPEED, and QUALITY to suit the pen mounted.
Step 2
Load paper of at least A4 size in the cutting plotter.
Step 3
Press the
PAUSE
key to enter the PAUSE mode.
Step 4
Press the
NEXT PAGE
key until the menu below appears.
INTERFACE
PEN UP/DOWN
Step 5
Simultaneously press the
and
NEXT PAGE
keys to display the menu below.
PEN UP SPEED
OFFSET FORCE
Step 6
Press the
NEXT PAGE
key until the menu below appears.
TEST
LENGTH UNIT
Step 7
Press the
F1/ORIGIN
key (TEST) to display the menu below.
CONDITION
SELF TEST
Press the
F1/ORIGIN
key (CONDITION) to initiate printing of a list of the cutting plotter's currently selected
conditions.
CAUTION : The pen carriage begins moving as soon as the
F1/ORIGIN
key is pressed to select
CONDITION in Step 7, so be sure to keep your hands and other objects away from
the cutting plotter's moving parts.
To Next Page
Loading...
