9 – 7
9.4 Cutting the Demo Pattern
Use this function to cut a demonstration pattern.
Step 1
Mount a cutter pen at the cutting plotter's pen holder and then set the blade type, FORCE, SPEED,
QUALITY, and CUTTER OFFSET to suit the cutter blade mounted.
Step 2
Load film in the cutting plotter.
Step 3
Press the
PAUSE
key to enter the PAUSE mode.
Step 4
Press the
NEXT PAGE
key until the menu below ap-
pears.
INTERFACE
PEN UP/DOWN
Step 5
Simultaneously press the
ENTER
and
NEXT PAGE
keys to
display the menu below.
PEN UP SPEED
OFFSET FORCE
Step 6
Press the
NEXT PAGE
key until the menu below ap-
pears.
TEST
LENGTH UNIT
Step 7
Press the
F1/ORIGIN
key (TEST) to display the menu below.
CONDITION
SELF TEST
Step 8
Press the NEXT PAGE to display the menu below.
DUMP
CUT DEMO
Press the
F2/TEST
key (CUT DEMO) to cut the demonstration pattern.
CAUTION : The pen carriage begins moving as soon as the
F2/TEST
key is pressed to select
CUT DEMO in Step 8, so be sure to keep your hands and other objects away from
the cutting plotter's moving parts.
To Next Page
Loading...
