9 – 6
Step 10
When the
F1/ORIGIN
key (ON) is pressed, the "DUMP MODE" message is displayed, so send data
to the cutting plotter from the computer in this status.
Upon receiving the data, the cutting plotter will begin printing it as codes.
Step 11
To cancel DUMP mode, turn the cutting plotter off then back on again.
NOTE : In DUMP mode, all of the data received by the cutting plotter from the computer is printed
out as ASCII character codes or as two-digit hexadecimal control codes. Upon receipt
of a READ-type command (excluding a request for the cutting plotter's status), the cutting
plotter outputs dummy data.
CAUTION : The pen carriage begins moving as soon as the
F1/ORIGIN
key is pressed to select
ON in Step 9, so be sure to keep your hands and other objects away from the cutting
plotter's moving parts.
To Next Page
Loading...
