GRAPHTEC CE2000-60 - Index

I – 1
A
AC power inlet............................................... 2-3
Aligning the coordinate axes........................ 6-7
AUTO PRE FEED mode .............................. 6-5
AXIS ADJ. function ....................................... 6-7
B
Baud rate ..................................................... 3-13
C
Centronics-compatible parallel interface
Cable ....................................................... 3-2
Connector ................................................ 2-2
COMMAND mode ........................................ 3-11
CONDITION function..................................... 9-2
Printing a list of current conditions ...... 9-2
Connecting to a power supply ..................... 3-2
Control panel ................................................. 2-4
Monitor lamps ......................................... 2-4
Control panel keys ................................. 2-4
Coordinate axes
Alignment................................................. 6-7
Rotation ................................................... 6-2
COPY function ............................................... 6-3
CUT DEMO function ..................................... 9-7
Cutter blades ................................................. 4-2
Adjusting the blade length ............ 4-4, 4-6
Blade numbers ................................ 4-6
Types and features ......................... 4-2
CUTTER OFFSET ...............................4-6, 4-10
Cutter pen plunger ................................ 4-2, 4-5
Mounting .................................................. 4-5
CUT TEST function ..................................... 4-12
Cutting area, setting the............................... 6-9
Cutting conditions
Setting procedure ................................... 4-7
Printing a list of...................................... 9-2
Cutting data ................................................... 6-3
Cutting mat..................................................... 2-2
Cutting results are unsatisfactory .............. 9-12
D
Data length................................................... 3-13
Data transfer rate ........................................ 3-13
Demo pattern, cutting the............................. 9-7
DIST ADJ. function ....................................... 6-6
Distance precision, adjusting the................. 6-6
DUMP mode................................................... 9-5
E
ENQ/ACK handshaking mode .................... 3-13
Error messages ............................................. 9-8
EXPAND function ........................................ 6-12
External dimensions ..................................... A-4
F
Film, loading .................................................. 3-4
FEED function................................................ 5-5
FORCE setting....................................... 4-6, 4-8
G
GP-GL
Command mode ...................................3-11
Command errors..................................... 9-9
Grit rollers ...................................................... 2-2
H
Handshaking modes.................................... 3-13
Hardwire handshaking mode...................... 3-13
Home sensors, enabling/disabling the ........ 8-3
HP-GL
Command mode ...................................3-11
Command errors................................... 9-11
I
Initial blade control................................ 8-2, 8-4
Interface conditions
Setting procedure .......................3-11, 3-13
Printing a list........................................... 9-2
Internal memory............................................. 6-3
INDEX