6 – 11
Step 6
Use the POSITION keys to move the carriage to the lower left corner of the desired cutting area. When
the carriage is satisfactorily positioned, press the
ENTER
key.
If you wish to use the default L.L. setting (0,0) instead of specifying a new L.L. position, however,
press the
F1/ORIGIN
key (DEFAULT) before pressing the
key.
Step 7
After the L.L. setting is completed, the menu below appears.
DEFAULT U.R.
( 0, 0)
Use the POSITION keys to move the carriage to the upper right corner of the desired cutting area.
When the carriage is satisfactorily positioned, press the
ENTER
key.
If you wish to use the default U.R. setting (0,0) instead of specifying a new U.R. position, however,
press the
F1/ORIGIN
key (DEFAULT) before pressing the
key.
Step 8
Press the
PAUSE
key to cancel the PAUSE mode.
NOTE : When the L.L. and U.R. settings are not separated by a distance of at least 5 mm or
are otherwise incorrectly specified, the message below appears. If this happens, set
the L.L. and U.R. settings once more.
WRONG PLOT AREA
To Next Page
Loading...
