GRAPHTEC CE LITE-50 - Page 49

3-13
Chapter 3 Cutting along Printed Data
[2] Creating data for printing & cutting
Cutting Data
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
1. &UHDWHGDWDIRUSULQWLQJFXWWLQJ
,WLVUHFRPPHQGHGWKDWWKHSULQWLQJGDWDDQGFXWWLQJGDWDEH
created on separate layers.
[3] Printing the created data
1. Print the created data.
%HIRUHSULQWLQJWKHGDWDVHWWKHOD\HUFRQWDLQLQJWKHFXWWLQJGDWDWREHKLGGHQ
CAUTION
Be careful to observe the following items as doing otherwise will lead to not being able to scan the
registration marks and perform the cutting.

Set the enlargement/reduction scale to 100%.

Set the printing position (center / bottom left, etc.) such that the relative positioning of the position of
the created document and the printed results are the same.
www.delinit.by