GRAPHTEC CE LITE-50 - Page 58

4-6
Chapter 4 Convenient Functions
Loading the Media upon Releasing the Push Rollers
:KHQORDGLQJWKHUROOPHGLDXSRQUHOHDVLQJWKHSXVKUROOHUVWKHUHDUHWZRW\SHVRIZD\VWRVFDQWKHUROOPHGLD
52//67$57('*(DQG52//&855(17326,7,21
1. 5DLVHWKHPHGLDVHWOHYHUVRQERWKVLGHVDQGUHOHDVHWKHSXVKUROOHUV
2. 6HWWKHSXVKUROOHURQWKHOHIWVLGHDWWKHSRVLWLRQRIWKH " mark.
6HWWKHSXVKUROOHURQWKHULJKWVLGHDFFRUGLQJWRWKHZLGWKRIWKHUROOPHGLD
3. When Scanning at the Edge of the Roll Media
,QVHUWWKHIURQWHGJHRIWKHUROOPHGLDLQXQWLOLWUHDFKHVWKHFXWWLQJPDWZKLWHWUDQVOXFHQWPDWEHKLQGWKH
push rollers.
Pass the roll media under the push roller positioning guide and load it so that it is parallel with the front
guide.
If the roll mediaLVLQVHUWHGWRRIDUWKHUHPD\EHFDVHVZKHQWKHPHGLDFDQQRWEHVFDQQHG
When Scanning the Roll Media at the Loaded Position
Insert the roll media until the position at which you wish to start cutting is at the home point.
Pass the roll media under the push roller positioning guide and load it so that it is parallel with the front
guide.
Scan at
Edge
Scan at
Loaded Position
Roll Media
Push Roller
Cutting Mat
Leading Edge of Roll Media
Home Point
Roll Media
Set to be parallel
Front Guide
Roll Media
Push Roller
4. Align the left edge of the roll media with the "I" marking of the " " mark on the front guide.
Roll Media Marking Roll Media
Front Guide
5. /RZHUWKHPHGLDVHWOHYHUVRQERWKVLGHVDQGORFNWKHSXVKUROOHUV