GRAPHTEC CE LITE-50 - Page 74

4-22
Chapter 4 Convenient Functions
4.6 Cutting upon Specifying the Cutting Position
6HWWKHSRVLWLRQDWZKLFKWRVWDUWFXWWLQJFXWWLQJRULJLQ7KHFXWWLQJRULJLQFDQEHVHWDWDQ\SRVLWLRQ
2QFH\RXDUHGRQHZLWKWKHVHWWLQJWRXFKWKH
([LWWRUHWXUQWRWKH+20(VFUHHQ
X
Y
Original Origin
New Origin
1. Touch the 3RVLWLRQWRRSHQWKH029(326,7,21VFUHHQ
2. 8VHWKH   DQG " to move the tool to the position
of the new origin and touch the
2ULJLQWRVHWWKHFXWWLQJ
origin.
www.delinit.by