GRAPHTEC CE LITE-50 - Setting Cutting Force and Offset Force

5-4
Chapter 5 Detailed Settings
Setting the Cutting Force
6HWWKHFXWWLQJIRUFHWRXVHWKHWRROZLWK$GMXVWWKLVYDOXHLIWKHFXWVDUHWRRVKDOORZRUWRRGHHS
&RQÀJXUDEOHUDQJH
1. Touch the &21',7,21RQWKH+20(
VFUHHQWRRSHQWKH&21',7,2112
setting screen.
2. 6HOHFWWKH&21',7,2112WRVHWE\XVLQJ
the "
" and " DQGWRXFKWKH)25&(
3. 8VHWKH " and " " to select the cutting
IRUFHDQGFRQÀUPWKHVHOHFWLRQZLWKWKH
&RQÀUP
Setting the Offset Force
6HWWKHFXWWLQJIRUFHIRULQLWLDOFRQWURORIIVHWIRUFHWKDWLVSHUIRUPHGGXULQJLQLWLDORSHUDWLRQVLQRUGHUWRFRQÀUP
WKHRULHQWDWLRQRIWKHEODGHWLS,IWKHRIIVHWIRUFHLVWRRZHDNWKHRULHQWDWLRQRIWKHEODGHPD\EHXQVWDEOHDW
WKHEHJLQQLQJRIWKHFXWDQGFDXVHWKHVWDUWLQJSRLQWDQGHQGLQJSRLQWWRQRWPDWFKXS
7KHRIIVHWIRUFHLVDOVRXVHGDVWKHFXWWLQJIRUFHZKHQSHUIRUPLQJURWDU\FRQWURORIWKHEODGHWLSZKHQRSHUDWLQJ
in the tangential mode.
&RQÀJXUDEOHUDQJH
1. )URPWKH0(18VFUHHQRSHQWKH722/
VFUHHQ
2. 7RXFKWKH2))6(7)25&(
3. 8VHWKH " and " " to select the offset
IRUFHDQGFRQÀUPWKHVHOHFWLRQZLWKWKH
&RQÀUP
www.delinit.by