GRAPHTEC CE7000-130 - Page 257

13-3
2
Select the rectangles and select "Effects" - "Rectangle to
Contour Cut Mark".
3
Select a type of registration mark on the "DesignCentral"
screen.
4
Press the "Options".
Specify the length and thickness of the registration mark
on the displayed "Graphtec Mark Options" screen.
Press the “OK”.
5
Press the on the "DesignCentral" screen.
Registration marks are created on the design screen.
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2