GRAPHTEC CE7000-40 - Page 273

13-19
3
When "Save As" screen is displayed, specify "USB
memory" to save the "XPF le".
* You can save it to an arbitrary folder and then move it to
USB memory.
When using Cutting Master 4
1
In Adobe Illustrator, select "Cutting Master 4" - "Cut/Plot"
from the File menu.
In Corel DRAW, select "Launch" - "Cut/Plot (CM4)" from
the tool bar.
* If using CorelDRAW version X7 or earlier, select from
the application launcher.
Before selecting the Cut/Plot, set the layer of printing
data to Hide .
Supplement
When the "Cut Contour" screen is displayed
for the rst time, the "Add Device" screen is
displayed. Follow the instructions on the screen
to select the model name to use.
•
For USB connection, select the "Graphtec
USB".
•
For network connection, select the "TCP/IP"
and then enter the IP address of the cutting
plotter.
2
The "Cut/Plot" screen is displayed.
Press the "Save to le".
3
When "Save As" screen is displayed, specify "USB
memory" and save the "XPF le".
* You can move to USB memory after saving in any folder.