GRAPHTEC CE7000-40 - Chapter 2: Preparing to Cut

2-1
Chapter 2: Preparing to Cut
This chapter describes how to prepare to start the cutting.
PRODUCT SUMMARY
2.1 Preparation of Cutter Plunger
2.2 Attaching a Tool
2.3 Loading Media (Paper or Marking Film)
2.4 Aligning the Push Rollers
2.5 About the Default Screen
2.6 Connecting to the Power
2.7 How to Use Control Panel
2.8 Setting Feeding Method
2.9 Pre Feed of Media (Paper or Marking Film)
2.10 Selecting Tool Condition
2.11 Running Cutting Tests
2.12 About Simple mode
2.12.1 Setting Page Length (Simple mode)
2.12.2 Origin Point Settings When conguring HP-GL (Simple
mode)
2.12.3 GP-GL Step Size (Simple mode)
2.12.4 Display Language Settings (Language) (Simple mode)
2.12.5 Display Length Unit Settings (Length Unit) (Simple mode)
2.13 Displaying Cutting Area