13-25
3
Press the "Options".
Specify the length and thickness of the contour cut mark
on the displayed "Graphtec Mark Options" screen.
Check the "Use Barcode".
Select the "Roll Media" from the "Barcode Type".
The margins of the printer driver selected in the
application are initialized in "Printer Margin". When
changing the printer, acquire margin information by
pressing the "Get Printer Margins".
Press the āOKā.
Supplement
Registration marks are placed automatically.
The position cannot be changed.
4
Press the on the "DesignCentral" screen.
Registration mark and bar code are created on the design
screen.
G1100JMAA-R
G1100JMAA-F
G1100JMAA-R
G1100JMAA-F
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Bar code Bar code
To Next Page
Loading...
