2-58
CAUTION
When the [2] key (CUTTER OFFSET) is
pressed, the tool carriage will start moving, so
take care not to get injured by the cutter blade.
7
Press the [2] key (CUTTER OFFSET).
3 cutting test patterns are cut, with current CUTTER OFFSET in the
center, and 1 each of CUTTER OFFSET increased and decreased for 1.
8
Press the [ENTER] key after completion.
It will return to CUT TEST menu screen.
9
Press the [ESC] key (CANCEL).
It will return to CONDITION setting screen.
10
Press the [COND/TEST] key.
It will return to default screen.
To Next Page
Loading...
