13
Click
Click the “Cut...” button. The registration marks are
read automatically. Do not touch the printed film
label sheet during the reading operation, as this
will affect the accuracy.
HINT
If a “Registration Mark Reading Failure”
error message is displayed, please refer
to the Craft ROBO User’s Manual (CD-
ROM).
Press the standby switch on your Craft ROBO and
confirm that the LED lamp is lit. Align the printed
film label sheet with the guide line, and then turn
the feed knob to feed the sheetso that it is aligned
with the top edge of the black cutting mat.
(For details on how to load media, please refer to
the Quick Start Instruction Sheet).
Load the printed film
label sheet so that
this registration
mark will be inserted
at the left of the
Craft ROBO when
you are facing the
Craft ROBO.
HINT
LED lamp
Standby
switch
Close the top cover.
Click the [Next] button to proceed to the
“Alignment” step. Click the [Next] button again to
proceed to the “Start cutting” step.
3
Load the printed film label sheet
in your Craft ROBO
4
Close the top cover
5
Perform Auto Registration Mark Reading
Media Trial Kit User Guide
2
To Next Page
Loading...
