GRAPHTEC Craft ROBO CC100 - Page 20

ROBO Master window
Preview window
Click the Preview buttons to display the Preview window.
Use the Change Display button to display the print data and the
cut data separately, or superimposed.
After checking the data displayed, click the Close button to
return to your usual Create Drawing window.
Preview button
Change display
buttons
Close button
Preview of cut data
and print data
Preview of cut data
Preview of print data
Load the [Card with Craft Paper Backing]
sheet from your Media Trial Kit in your
printer.
Click the Output to Printer button to
display the Output to Printer window. Check
that your printer is displayed in the printer
box and then click the [OK] button to start
printing.
Printer output button
20
Click the Output to Craft ROBO button , confirm that the
driver name reads Graphtec Craft ROBO, and then click the
[OK] button to start the Craft ROBO Controller.
Select “Card with Craft Paper Backing” in the Media Type
box.Click the [Next] button to proceed to the “Blade cap
adjustment” step. Attach the yellow cap displayed on the
screen to the cutter plunger tip.
Select “Card with
Craft Paper Backing”
Click
Output to Craft ROBO button
22
Print the data you have created and load the sheet in the Craft ROBO
1
Check the Cut line and Print data
2
Print the data you have created
3
Specify the cutting conditions
Media Trial Kit User Guide
2