1-4
1.3 Assembling the Scanner
Please see the separate Stand Assembly Instruction Manual for instructions on how to
assemble the stand.
Attaching the document support plates
Always be sure to install the document support plates, irrespective of the type of documents
to be scanned.
(1) Take one of the document support plates provided, and insert its hooks into the slots at
the rear of the scanner. Insert the hooks from the top of the slots.
Document support plateHooks
(2) Attach the other document support plates in the same manner.
Checkpoint
Detach the document support plates when moving or packing the scanner. Lift the
plates up and out of the slots to detach them.
Attaching and using the cable clamp
Attach the cable clamp to the scanner, and then pass the power cable and USB cable
through the clamp to fasten them in place.
Caution
Be sure to attach the cable clamp to the scanner and use it to fasten the power
cable and USB cable in place. Failure to do so may affect the scanning operation.
Attaching the clamp
(1) Using a soft cloth that has been soaked in water or diluted neutral detergent and then
firmly wrung out, wipe off any dust or dirt on the surface of the attachment location
before attaching the cable clamp.
Cable clamp attachment location
To Next Page
Loading...
