22 / 25
8. Precautions for use
□ Compliance with equipment use
If you hold the cured object or tray plate right after curing, you may get burned or other
injury to your hands due to the hot temperature during curing, so be sure to cool it
sufficiently or wear gloves before taking out the cured object.
If you open the door immediately after curing or during curing, the UV LED may not turn
off right away. To protect your eyes, open the door after checking whether the inside of the
chamber is lit while the door is closed.
Do not use the product for any other purpose than post-curing.
Do not open the door during Curing process.
If hardening is carried out for a long time, the door may swell due to internal heat, so use
after sufficient cooling.
Do not arbitrarily disassemble or modify the product.
After turning off the power switch of the equipment, do not turn it on right away, but turn
it on again after about 5 seconds.
Please note that product damage in situations where the above precautions are not followed
are not subject to the free A/S regulation even during the quality warranty period.
To Next Page
Loading...