25 / 25
10. Notification Message
If the replacement cycle is reached according to the recommended LED usage time, the
above alarm will be displayed, so please contact the C/S team to replace the LED.
It is an alarm that the temperature of the inside & LED Board is high and is being cooled to
lower the temperature. Please use the curing machine after the temperature drops below
the proper temperature and the fan stops working.
This is an alarm when the internal nitrogen saturation does not exceed a certain level after
nitrogen injection is selected. Check the condition of the compressor and the air line, and
check if any foreign substances are blocking the nitrogen inlet inside.
11. Repair inquiry
If the contents are not described in the service manual, or if the symptom is not relieved after
referring to it, contact the C/S team to check.
To Previous Page
Loading...