GRASS VALLEY ADVC3000 - DIP Switch Settings

Chapter 2 - Basic Operations
18
1-3. DIP switch settings
The rear panel of the ADVC3000 unit has the following DIP switches. Default SW3, SW4 settings may
differ depending on the place of purchase.
PHY SPEED
Update Mode
Video Format
PAL/SECAM
(When SW3 is set to ON)
NTSC Setup Level
(When SW3 is set to OFF)
S400
Normal
NTSC
PA L
0 IRE
S200
Update
PA L
SECAM
7.5 IRE
Reserved
Reserved
• SW1: PHY Speed
Designates the PHY speed.
OFF: S400 ON: S200
• SW2: Update Mode
Used to update the internal software.
(Set this switch to the OFF position for normal operations.)
OFF: Normal ON: Update
• SW3: Video Format
Designates the video signal format.
* Enabled only when the setting in the menu option “107 video standard” is “set by DIP switch”.
OFF: NTSC ON: PAL
• SW4: PAL/SECAM (When SW3 is set to ON)
* Enabled only when the setting in the menu option “107 video standard” is “set by DIP switch”.
OFF: PAL ON: SECAM
: NTSC Setup Level (When SW3 is set to OFF)
* Enabled only when the setting in the menu option “107 video standard” is “set by DIP switch”.
OFF: 0 IRE ON: 7.5 IRE
• SW5: Reserved
Not used. (Set this switch to the OFF position for normal operations.)
• SW6: Reserved
Not used. (Set this switch to the OFF position for normal operations.)
CAUTION
• Turn off the power of ADVC3000 unit before making any changes for DIP switch settings.
• DIP switches 5 and 6 should be set to OFF. Otherwise, malfunction may occur.
20