Chapter 2 - Basic Operations
21
6. On the Main screen 1: Input time code
TC 00:00:03:22 ...........For PAL/NTSC NDF (Non Drop Frame)
* A colon is used between seconds and frames as a delimiter.
TC 00:00:03;22 ...........For NTSC DF (Drop Frame)
* A semicolon is used between seconds and frames as a delimiter.
TC --:--:--:-- .................No DV signal output.
* Free-run time code is used during built-in color bar output or when time code is not
input.
* “T
_” is displayed if the time code set by “301 TC source” cannot be found.
On the Main screen 2: Users bit
UB 00 00 00 00 ...........The letters or numbers designated by the user are displayed.
UB -- -- -- -- .................No DV signal is output.
* “U_” is displayed if the users bit cannot be found.
7. Audio monitor status
----- ..............................The channel is not monitored.
8. 9-pin remote system
A .................................REMOTE A is selected.
B .................................REMOTE B is selected.
If blank ........................The remote connectors are disabled.
23
To Next Page
Loading...
