July 3, 2007 K2 Storage System Instruction Manual 111
Configuring the redundant server
Configuring the redundant server
You must wait for the primary K2 Media Server to restart before continuing. To
verify, from the control point PC open the MS-DOS command prompt and use the
“ping” command.
For Level 2 redundant, after you have configured the first K2 Media Server (server
A) you next configure the redundant K2 Media Serer (server B).
1. In the K2 System Configuration application tree view, select the K2 Media Server
you are configuring as server B.
2. Click the
Configure button. The Configure K2 Storage System Server wizard
opens. Follow the on-screen text to configure the server for a Level 2R K2 Storage
System, as described in the following table. Some screens require no input from
you, as they are based on the configurations already completed on a previously
FTP Server Configuration
Do not modify these settings. Leave at default values of Max FTP
streams = 4 and FTP Data Socket Timeout = 60. Only qualified Grass
Valley personnel should specify other values, as these settings are
intended for use only with custom systems designed by Grass Valley.
Click Next
Completing the
Configuration Wizard
Click Finish. The wizard closes. The K2 Media Server restarts. Wait
until all startup processes have completed before continuing. If you are
not sure if startup is complete, wait 10 minutes.
On this page… Do this…
To Next Page
Loading...
