GRASS VALLEY K2 - Page 130

130 K2 Storage System Instruction Manual July 3, 2007
Chapter 4 Installing the Level 3 Storage System
the switch. (If your PC or terminal has a 25-pin serial connector, first attach a 9-pin
to 25-pin straight-through adapter at one end of the console cable.)
3. Turn on the PC’s power and start the PC terminal program.
4. Press
Enter two or three times and you will see the copyright page and the message
“Press any key to continue”. Press a key, and you will then see the switch console
command (CLI) prompt.
NOTE: If you press Enter too many times and get past the log in, enter the
command EN to get into the command line.
5. Type the following, then press
Enter:
menu
If prompted to save the current configuration, answer no (press the n key) to
proceed. The main menu opens.
6. On the main menu, choose
Switch Configuration, then press Enter.
7. Select
IP Configuration, then press Enter.
8. Press the right-arrow key to choose
Edit, then press Enter. Tab to fields and enter
information as follows:
a. Change
Gateway to be the default router.
b. Tab to the
IP Config (DHCP/Bootp) field and use the Space bar to select the
Manual option.
c. Tab to the
IP Address field and enter the switch’s control network IP address.
Refer to “Networking tips” on page 56.
d. Tab to the
Subnet Mask field and enter the subnet mask used for your network.
9. Press
Enter, then right-arrow to Save. Press Enter and revert to previous menu.
10.Select
Return to Main Menu and press Enter.
11.From the main menu, chose
Console Passwords and press Enter. The Set Password
Menu opens.
12.Chose
Set Manager Password and press Enter.
13.When prompted for the password, type a password of up to 16 ASCII characters
with no spaces and press
Enter. The password can be one that is used on other K2
devices, such as “adminK2” or “K2admin”, or it can be your site's administrator
password.
14.When prompted to enter the password again, retype the password and press
Enter.
15.Select
Return to Main Menu and press Enter.
16.From the main menu, tab to
Command Line (CLI) and press Enter. The command
prompt appears.
17.Type the following, then press
Enter:
configure
You are now in configuration mode.