132 K2 Storage System Instruction Manual July 3, 2007
Chapter 4 Installing the Level 3 Storage System
d. Down arrow until at the bottom of the list of ports.
e. Right-arrow over to the Group column.
f. Use the Space bar and set the bottom 10 Gig port to
Trk1. Depending on the
switch model, this is port 26 or port A3.
g. Set the next port up also to
Trk1.
h. Press
Enter, then right-arrow to Save. Press Enter and revert to previous menu.
26.Select
Return to Main Menu and press Enter.
27.From the main menu, tab to
Command Line (CLI) and press Enter. The command
prompt appears.
28.Check the version of firmware currently installed on the switch. Type the
following, then press
Enter:
show flash
Information is displayed similar to the following example:
HP_iSCSI_switch1# show flash
Image Size(Bytes) Date Version
----- ---------- -------- -------
Primary Image : 3287779 03/15/05 M.08.66
Secondary Image : 3287779 03/15/05 M.08.66
Boot Rom Version: I.08.07
Current Boot : Primary
29.Check the Primary Image Version and refer to your K2 Storage System Release
Notes for information about currently supported versions. Then proceed as follows:
•If K2 Storage System Release Notes instruct you to change the firmware on the
switch, do so before continuing. Refer to the documentation you received with
the switch for instructions to change the firmware. Then continue with the next
procedure “Configuring the GigE switch via the Web interface”.
•If K2 Storage System Release Notes confirm that the version on the switch is a
currently supported version, continue with the next procedure.
30.Type the following, then press
Enter:
menu
The main menu opens.
31.From the main menu, choose
Reboot Switch and press Enter. When prompted
“Continue Reboot…?', answer yes (press the y key) to proceed. The switch restarts.
32.You can now use the switch’s web browser interface for further configuration, as
instructed in the next procedure.
33.Close the PC terminal program and disconnect the console cable.
Continue with the next procedure “Configuring the GigE switch via the Web
interface”.
To Next Page
Loading...
