182 K2 Storage System Instruction Manual July 3, 2007
Chapter 5 Installing the Level 3R Storage System
5. Set Spanning Tree to On and click Apply Changes. If prompted, log in with the
switch’s administrator username and password.
6. Click
Port Configuration.
7. If you do not need trunks, such as on a one-switch system, skip to the next step in
this procedure. If you need trunks, such as on a two-switch system with ISLs, do
the following:
a. Select (Ctrl + Click) the trunked ports. Typically the trunked ports are at the
bottom of the list. In the configuration for 10 Gig ISLs, two of the ports at the
bottom of the list are labeled Trk1.
To Next Page
Loading...
