GRASS VALLEY K2 - Page 186

186 K2 Storage System Instruction Manual July 3, 2007
Chapter 5 Installing the Level 3R Storage System
b. Select all the odd numbered ports. (Tip: Use Ctrl + Click.)
c. In the Mode drop-down list, select
Untagged, then click Apply. This removes the
odd ports from the default (Control) VLAN.
If you have a trunk, do not configure it as “Tagged”. Media VLAN traffic
(iSCSI) does not go over the trunk.
16.Click the
VLAN Configuration tab.
17.If you have a trunk, configure the default (Control) VLAN as follows:
a. In the DEFAULT_VLAN row, click
Modify.
b. In the Current Mode list box, scroll down and select the trunk.
c. In the Mode drop-down list, select
Tagged, then click Apply. This allows default
VLAN traffic (non-iSCSI) to go over the trunk.
18.Click the
VLAN Configuration tab.