July 3, 2007 K2 Storage System Instruction Manual 215
Configuring the server 1A - Part 2
iSCSI Bridge Server
Configuration
This page manages the
components that bridge
between iSCSI (the GigE
media network) and the
Fibre Channel connection to
the RAID storage. You
configure network settings
on the iSCSI adapters and
the page validates that the
Fibre Channel adapter is in
place and that the media
LUNs are visible as iSCSI
targets.
For Level 3 redundant, select
Primary.
Select an iSCSI adapter and click
Modify. A network configuration
dialog box opens. Enter the media network IP address and the subnet
mask and click
Apply. Do the same for the other iSCSI adapter.
Click
Check. The Validation Report opens.
Confirm that the iSCSI configuration is successful. Close the Validation
Report and then click
Next.
Database Server
Configuration
Enter the name or IP address of K2 Media server 1B. This is the
redundant partner of the server you are now configuring.
Click Next.
On this page… Do this…
To Next Page
Loading...
