GRASS VALLEY K2 - Page 247

July 3, 2007 K2 Storage System Instruction Manual 247
Setting up the Nearline GigE switches
b. Click Modify Selected Ports.
c. For the trunked ports, set Port Enabled to
Yes. On some switch models, the 10
Gig ISL ports are disabled by default, so make sure you enable them. Leave
Mode as default of
Auto.
d. Set Flow Control as follows:
- For the 3400cl series switch, set to
Disable.
- For the 2900 series switch, set to
Enable.
If you have both 3400cl series and 2900 series on your network, having different
Flow Control settings (disable for 3400cl, enable for 2900) does not cause
problems.
e. Click
Apply Settings.
8. On the Port Configuration page, do one of the following:
• If you do not have trunks, select all ports.
• If you have trunks, select the remaining ports (the ports not trunked).
This setting
varies depending
on switch model.
Set as instructed
in text.