July 3, 2007 K2 Storage System Instruction Manual 55
Configuring RAID
• “Binding disk modules”
Refer to “Prerequisites for initial configuration” on page 49 to confirm that the RAID
storage is ready for configuration.
Configuring RAID network and SNMP settings
Use the Storage Utility to configure the following settings for the Level 2 RAID
chassis:
•IP address
• Subnet mask
• Gateway Address
• SNMP trap destinations
For Level 2 RAID, network and SNMP settings are set and stored on the RAID LAN
card. Therefore the combined RAID storage devices, including the one or two RAID
controllers and the optional Expansion chassis, is a single entity on the control
network. In addition, the RAID storage device is configured by default for the SNMP
community name “public”. If your site’s policies require using a different SNMP
community name, contact your Grass Valley representative.
To configure these settings, do the following:
1. Launch Storage Utility from the K2 System Configuration application as in the
previous procedure. If the RAID chassis has two controllers, you will configure the
network settings on the controller connected to K2 Media Server you are currently
configuring.
2. As prompted, wait while Storage Utility gathers system information, then Storage
Utility opens.
3. In Storage Utility tree view, expand the node for the L2 RAID, right-click the icon
for a L2 RAID controller, and select
Configuration | Network Properties. The
Controller Network Settings dialog box opens.
To Next Page
Loading...
