23 / 36
S1033_jh_V1_de
Switch the transmitter off
If you push on the POWER button, by switched on transmitter,
for more than 2 sec. a safety query appears (see image). Select
the desired option with one of the pouch pads (up or down) and
push the SET button.
This safety query avoids an accidental switch off of the transmit-
ter while in use.
Binding
The description of the binding process can be found in
the Part 2 of the manual.
To use a transmitter you must associate a receiver to the trans-
mitter. This binding process is essential for the use of the model!
The precise binding process follow-up is described in the sec-
tion "Binding" of the Part 2 of the manual and in the related
receiver manual.
NOTICE
The process is different for the various receiver types.
Binding-principle step by step:
1. Select the "main settings" menu in the transmitter
2. switch the RF module OFF
3. Connect the power supply to the receiver
... receiver with binding button:
• Push and hold the binding button at the receiver
• Start the binding process in your transmitter in the main set-
tings menu
... or receiver without binding button:
• The receiver is automatically in binding mode after switch on
• Start the binding process in your transmitter in the main set-
tings menu
4. If the binding process has been unsuccessful, repeat the
process.
Power off
Cancel
Mod.name
Stick mode
1
n/d
Base setup model
BD1
GRAUBELE
BD2
Module
HoTT
n/d
To Next Page
Loading...
Need help?
General
Weight and Dimensions
