GRAUPNER MC-28 - Programming Manual

80 pages

To Next Page

Programming manual

Part 2

mc-26 / mc-28 / mc-28 4D

MC-28

esc

set

No. S1036 / 33028 / S1033

16 channel HoTT 2,4 GHz transmitter

Main Page

Default Chapter3
- Table of Contents3
Introduction7
- Service Centre7
Use and Menu Functions8
- Short-Cuts8
Definition of Terms9
Receiver Configuration10
- Fixed-Wing Models10
- Helicopter Models11
- Vehicles, Boats11
- Copter12
- Receiver Power Supply12
Symbols Explication13
Menus Description13
Meaning of the Warnings13
Model Selection14
Copy/Delete15
- Export to SD Card16
- Import from SD16
Suppress Menus18
Suppress Models18
Model Basic Settings18
- Control Mode19
- Binding Type19
- Module20
- Receiver Binding21
- Receiver Output22
- RF Module22
- Range Test22
- DSC Port23
- Throttle Cut23
- Switch-On Warning24
- Auto Trim24
- Timer Auto Reset24
Model Type25
- Motor on CH126
- Tail26
- Ailerons/Flaps27
- Brake Offset27
Servo Adjustment27
Sticks Setting29
Controls Setting29
Dual Rate / Expo31
Throttle Curve32
Switch Display34
Control Switch34
Logical Switch35
Announce35
Phase Setting36
- Motor37
Phase Assignation38
Phase Trim38
Channels Without Delay39
Timers (General)39
Phase Timer41
Wing MIX42
- Programming of the Wing Type43
- Model Type: "1AIL43
- Model Type: "1AIL 1FLAP43
- Model Type: "2AIL44
- Model Types with "2/4AIL 1/2/4FLAP45
- Model Type: "2AIL 1FLAP45
- Model Type: "2AIL 2FLAP45
- Model Type: "2AIL 4FLAP46
- Model Type: "4AIL 2FLAP46
- Model Type: "4AIL 4FLAP47
- Multiflaps Menu48
- Brake Setting50
- AIL -> RUD (Aileron -> Rudder)52
- FLAP -> ELE (Flaps -> Elevator)52
Free Mixers53
MIX Act. / Phase56
Only MIX Channel56
Dual Mixer57
Fail Safe57
Trainer58
Transmitter Output58
Profitrim59
Trim Memory60
Telemetry60
Channel Sequencer61
Multichannel62
MP-3 Player64
Basic Settings64
- Loudspeaker (LS) Voice / Vario / Buttons64
- Owner64
- Control Mode (Preset)65
- Stick-Type (Only by MC-26)66
- Module66
- DSC Port66
- Pitch Min66
- Contrast (Upper/Lower Display)66
- Display Light66
- Switch-On Melody67
- Battery Alarm Threshold67
- Switch-On Warning67
- Touch Sensitivity67
- DATA Sel67
- Ph. Name 167
- BT Headset and Following Lines67
Vibration68
Servo Display68
Servo Test68
Key Lock68
Info Display69
Digital Trim / Throttle Switch-Off Trim (Function)69
Heli Programming70
Throttle Curve (Heli)73
Sticks Setting (Heli)73
Control Adjust (Heli)73
Ring Limit75
Firmware Update76
- Update through Memory Card76
- Update through USB Port77
- Problems During Firmware Update77
Declaration of Conformity77
Notes on Environmental Protection78
Care and Maintenance78
Warranty78

GRAUPNER MC-28 - Programming Manual

Table of Contents

Other manuals for GRAUPNER MC-28

Related product manuals