GRAUPNER MC-28 Programming Manual

39 / 80
33028_mc_28_Teil2_jh
Note
The trim of "Elevator", "Aileron" and "Rudder" is factory-set to
"Global". This setting can be changed at any time to "phase-specific"
in the "Sticks setting" menu.
Channels without delay
In this menu, you can switch off the switching delay set in the "Phase
setting" menu for individual control channels that are dependent on
the phase.
• Switch to the corresponding phase (this is shown in the lower left
corner of the display).
• Set the desired channel through the selection keys.
• Use the SET button to change the channel (normal / reverse)
Timers (general)
The model timer, battery timer, Timer up and Timer middle are set
here.
Model time
This timer shows the currently recorded used time of the active
model memory. To switch the time recording manually, assign a
switch in the right column.
The buttons
t u or  of the right touch-pad reset the timer
to "0:00h".
Batt time
This timer shows the use time of the battery. The timer will be reset
as soon as the battery is fully charged. The time is added at each use
of the transmitter.
The buttons
t u or  of the right touch-pad reset the timer
to "0:00h".
Timer up and middle
These two timers are located in the upper right half of the basic dis-
play. A different name can be assigned. The function and use mode
depend on the name. Regardless of the name, the "up" and "middle"
timer can be programmed backwards or forwards as a "timer".
Stop/motor
These two timers will start and stop with a switch, in the column "
". Move the marking frame with the selection key  over the
"Timer" column to the right side to reach the column.
Phase settings
Phase trim
Annnounce
Timers (general)
Phase assignment
Non-delayed chan
Non-delayed channels
non-delay
normal
Normal
7 8 9
10
11
12
Non-delayed chan
Timers (general)
Phase timers
Wing mixers
Free mixers
MIX active/phase
Model time
Batt. time
Top:
Centr:
Stop
Log t.
Timer
–––12:34h
1:23h
0:00
0:00

GRAUPNER MC-28 Specifications

General

Proper use	Helicopter
Product type	Remote control
Product color	Black, Silver
Frequency band	2.4 - 2.484 GHz
Menu languages	DEU, DUT, ENG, ESP, FRE, ITA
Channels quantity	16 channels
Brand compatibility	Graupner
Throttle (TH) function	Yes
Compatible memory cards	MicroSD (TransFlash)
Number of memory records	120
Maximum operating distance	3000 m
Operating temperature (T-T)	-15 - 55 °C
Power consumption (charging)	400 mA
Operating voltage (max)	4.35 V
Operating voltage (min)	3.4 V

Weight and Dimensions

Depth	235 mm
Width	228 mm
Height	66 mm
Weight	1250 g