66 / 80
33028_mc_28_Teil2_jh
Stick-type (only by mc-26)
Potentio. - Setting for when standard gimbal sticks with potentiome-
ters are used.
4D-stick - Setting for when optional 4D-stick gimbal sticks with poten-
tiometers are used.
Module
The transmitter is equipped with a HoTT RF module as standard.
External RF modules from other manufacturers can be connected to
the DSC and DATA sockets. The selection of "HoTT", "EXT." or "SP."
can be switched specifically for the model memory.
DSC port
Here you can specify the modulation type of the signal on the DSC
socket.
PPM 10 - Output of channels from 1 to 5
PPM 16 - Output of channels from 1 to 8
PPM 18 - Output of channels from 1 to 9
PPM 24 - Output of channels from 1 to 12
Pitch min
In this line, specify the direction of operation of the throttle / pitch
control stick. All other options of the helicopter program involving
the gas and pitch function are dependent on this setting. (i.e. Throt-
tle curve, idle trim, channel 1 => throttle, tail rotor mixer)
"Front" - minimum pitch setting at the front, the throttle / pitch con-
trol stick (CH1) points away from the pilot.
"Rear" - minimum pitch setting at the rear, the throttle / pitch control
stick (CH1) points to the pilot.
Contrast (upper/lower display)
Here you can set the contrast value of the two displays.
Adjustment range -20 to +20. Simultaneously tap the selection
keys
t u or of the right touch pad to reset to "0".
Display light
Here set the duration of the display background lighting. Settings
possibilities:
• "Unlimited" - The background lighting always stays on
• 30, 60, 120 s - The backlight remains on for the selected time
when no touch panel button is pressed.
• "Off" - The background lighting is always off.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
