77 / 80
33028_mc_28_Teil2_jh
Update through USB port
Download the software package from the Internet, and unzip it on
your computer. Connect your switched off transmitter with your PC,
by using the included USB cable, supplied with the package content.
Plug the USB cable directly into the micro USB port of the transmit-
ter and the other end to a free port in your computer. All other infor-
mation can be found in the instructions that come in the software
package.
Problems during firmware update
Problem: POWER switch without function
If a firmware update for the transmitter is unsuccessful or the trans-
mitter program freezes and the transmitter cannot be turned off
using the "POWER" switch, then remove the transmitter's battery
after setting the switch to "POWER = OFF" position, or pull the plug
from the transmitter battery, reconnect it after few seconds and
leave the transmitter switched OFF.
Download the update file from internet and save it in the "RECOV-
ERY" folder in your SD card. Then change the file name to "R280.bin".
Insert the SD card in the transmitter.
Push and hold the Ctl 5 and Ctl 6 buttons at the same time to the top
and push the POWER button.
Now push and hold to the lower side within 2 - 3 seconds the Ctl 5
and Ctl 6 for about 10 seconds.
Wait at least 30 seconds. In the display no image will be shown.
During the update the transmitter cannot be switched on.
After 30 seconds the transmitter switches on.
Declaration of conformity
S1033 / S1036 / 33028 - mc-26 / mc-28 / mc-28 4D
Graupner/SJ declares that the product is conform to EU norms.
EMV 2004/108/EC:
EN 301 489-1 V1.9.2
EN 301 489-17 V2.1.1
EN 62479:2010
LVD 2006/95/EC:
EN 60950-1 + A11 + A1 + A12 + A2:2013
R&TTE 1999/5/EC:
EN 300 328 V1.8.1
EN 62311:2008
FCC ID: SNL-1600710 / SNL-1600770
IC ID: 20961-1600770 / 20961-16007100
To Next Page
Loading...
Need help?
General
Weight and Dimensions
