10 / 36
33032_jp_V1
For your safety by handling the battery
CAUTION
Protect all equipment from dust, dirt, moisture. Only use in
dry locations.
Do not use any damaged battery. Risk of injury!
Any alterations to the battery can cause serious injury. Risk
of fire!
Batteries may not be heated, burned, short-circuited or
charged with excessive current or with reversed polarity.
While they are being charged, the batteries must be placed
on a non-flammable, heat-resistant and non-conductive sur-
face. Combustible or highly flammable objects are to be kept
away from the charging area. Batteries must be monitored
while they are being charged.
The maximum quick charging current specified for the
respective cell type may not be exceeded.
If the battery heats up above 60°C while it is being charged,
stop charging and let the battery cool down to approximately
30 - 40°C.
Never charge batteries that have already been charged, are
hot or are not fully discharged. If a cell in a battery pack has
become particularly hot following a quick-charge process,
this may indicate a defect in that cell. Do not use the battery
pack any more!
The batteries must not be modified. Do not directly solder or
weld the cells.
If handled improperly, there is a danger of fire, explosion, irri-
tation and burns. To extinguish a fire use: water, CO2, sand.
Leaked electrolyte is caustic and should not be touched or
come into contact with your eyes. In case of emergency,
rinse with a large quantity of water and consult a Med. Doc-
tor.
To Next Page
Loading...
Need help?
General
