EN - 27
ADJUST HANDLEBAR HEIGHT
See Figure 34.
Handlebar height may be adjusted for
operator comfort.
1. Place unit in service position. See
Service Position on page 18.
2. Remove pins from handlebar and raise or
lower handlebar to desired height.
3. Reinstall pins to secure position.
ADJUST PARKING BRAKE
CABLE
If parking brake lever does not engage
parking brake shaft, brake cable may need
adjustment. See Figure 35.
1. Disengage parking brake.
See Figure 36.
2. Loosen upper jam nut and tighten the
lower jam nut until tight against cable
bracket.
3. Reposition rubber boot against
adjustment barrel.
4. Check cable adjustment and readjust as
necessary.
5. Check parking brake and adjust, if
necessary. See Adjust Parking Brake on
page 28.
Figure 33
1. Upper Jam Nut
2. Lower Jam Nut
3. Rubber Boot
1
3
2
Figure 35
1. Parking Brake Shaft
1
Figure 36
1. Upper Jam Nut
2. Lower Jam Nut
3. Rubber Boot
1
2
3
To Next Page