Why does the hour meter continue to run when engine is not running on my Gravely ZT2148?
If the hour meter on your Gravely Lawn Mower continues to run when the engine is off, it is likely because the ignition key is in the run position. Simply turn the ignition key to the off position.
Why does my Gravely ZT2148 Lawn Mower engine run rough?
A rough-running engine on your Gravely Lawn Mower could be due to: * The choke being engaged; disengage it. * A plugged air filter cartridge; clean or replace it.
Why does my Gravely ZT2148 engine overheat?
Your Gravely Lawn Mower engine may overheat due to: * Low engine oil level; add engine oil. * A plugged cooling system; clean the cooling system.
What to do if my Gravely ZT2148 Lawn Mower does not travel in a straight line?
If your Gravely Lawn Mower isn't traveling in a straight line, check the following: * Incorrect tire pressure; check and correct the tire pressure. * Steering levers need adjustment; adjust the steering levers.
Explains the meaning of safety alert symbols (!, DANGER, WARNING, CAUTION) for hazard recognition.
Emphasizes replacing decals and refers to Figure 2 for their locations on the unit.
Steps to set up the unit for operation, including seat and steering lever installation.
Directs the user to the Operation section to verify all controls function correctly.
Identifies and locates all controls and features of the mower, referencing Figure 4.
Details tests to ensure the safety interlock system is functioning properly for safe operation.
Procedure to quickly and safely stop the unit and engine in an emergency situation.
Detailed steps for starting the engine, including choke and throttle usage, and shutting it down.
Steps for starting the engine, engaging the PTO, and moving the unit with steering levers.
Reminder to test the safety interlock system each time the unit is operated for safety.
Refers to testing the time it takes for mower blades to stop after PTO disengagement.
Detailed steps for removing and installing the PTO belt, including idler spring tension care.
How to test if mower blades stop within the specified time after PTO disengagement.
Guidance on checking and adjusting the electric clutch air gap for proper engagement/disengagement.
Lists probable causes and corrections for issues preventing the engine from cranking or starting.
Identifies potential causes like choke or air filter issues, and their corresponding solutions.
Troubleshooting steps for when the unit fails to move, related to transmission bypass or belt issues.
Covers issues with PTO engagement, blade operation, and shutdown, linking to belt and clutch adjustments.
Addresses engine overheating due to low oil or plugged cooling systems, referencing the Engine Manual.
Troubleshooting faulty parking brake adjustment or function.
Troubleshooting poor cutting quality, focusing on deck leveling and blade sharpness/condition.
General| Engine Displacement | 726 cc |
|---|---|
| Cutting Width | 48 inches |
| Fuel Capacity | 3.5 gallons |
| Cutting Height | 1.5 - 4.5 inches |
| Spindle Material | Aluminum |
| Warranty | 3 years |
| Deck Material | Steel |
| Blade Tip Speed | 18, 000 ft/min |
| Turning Radius | Zero-Turn |
To Next Page
