Stopwatch Mode
Split Mode
18
This feature can record up to 10 split times from 0 ~ 9’ 59" 99. Lap time
can also be recorded at the same time.
(1) While in the Stopwatch mode,
press the P+S button to go to
Split Mode. Two sec. later,
0’00" will display.
*if there are recorded time stored
in the memory, the 0’00" will flash.
To clear the memory, hold down
T button over 5 sec.
(2) By pressing the S button once,
the stopwatch will start. At each
split point, press T button to
store and display the lap time.
(3) After the lap time, the display
will show the current count time.
To stop, press the S button once.
2 sec later, Standby
mode will display.
press S button to start.
press T
button
Press S button to stop.
Number of total split
time stored will display
followed by the total
time.
To Next Page
Loading...
