To Next Page

To Previous Page

4. OPERATION GUIDE

NOTES :

▪ The drain bucket must be correctly locked into place for the dehumidier to work.

▪ Do not remove the drain bucket while the unit is running.

▪ Each time you press a button on the control panel, the appliance emits a beep.

4.2. BUTTON FUNCTIONS

POWER ON / OFF

Press this button to turn the dehumidier ON or OFF. When turned on, the power indicator

on the control panel will light up and the dehumidier will emit a beep.

INCREASE / DECREASE

Press these keys to adjust the desired humidity level between 35 and 80 %. Each press of

the "+" or "−" button increases or decreases the humidity level by 5 %.

To set the unit to Nonstop mode, use the "−" button and decrease the humidity level under

35 %. In this mode, the unit will operate continuously using its maximum dehumidication

settings stopping only when the drain bucket reaches full capacity (unless a drain hose has

been connected to the unit).

Tip : When rst using the dehumidier, set the humidity level to 45 % or 50 %. Allow

at least 24 hours for the dehumidier to achieve the humidity level. If after that time

the air is still damper than desired, set the humidity level to a lower setting or select

Nonstop mode for maximum dehumidication.

FAN SPEED SELECTION

Press this button to set the fan speed of the dehumidier to your desired comfort level.

Speeds include : High, Medium and Low. The corresponding indicator will light up for each

speed.

SET TIMER

To set a Switch-Off Timer, press this button while the unit is running. To set a Switch-On

Timer, press this button while the unit is turned off.

Press once to set a time value of 2 hours. Press again to set a time value of 4 hours. The

corresponding indicator will light up on the control panel. Pressing a third time will reset the

time value to zero and the time indicators will turn off.

FILTER REMINDER RESET

After 250 hours of operation, the Filter indicator will light up to remind you to clean the

lter. After having cleaned it, press this button to turn off the Filter indicator and reset the

operating hours to zero.

PUMP FUNCTION (models with integrated water pump only)

Hold down this button for 3 seconds to activate the water pump function. The Pump mode

indicator will light up. When the drain bucket becomes full, the pump will automatically start

draining the water away.

Note : A drain hose must be connected to the pump port for this mode.

AND / OR

Gree GDN50BA-A3EBA2D User Manual

Questions and Answers: