U-Match Series DC
Inverter Service Manual
building, make sure that the electrical insulation must comply with applicable standards.
(QVXUHWKDWWKHSODFHRILQVWDOODWLRQLVIDUIURPWKHDUHDZKHUHWKHLQÀDPPDEOHRUH[SORVLYHVXEVWDQFHV
DUHVWRUHGWKXVWRDYRLGSRVVLEOHH[SORVLRQRU¿UHGXHWROHDNDJH
1.2.2 Installation Site
(1). Install the unit at a place where is strong enough to withstand the weight of the unit.
(2). 7KHDLULQOHWDQGRXWOHWRIWKHXQLWVKRXOGQHYHUEHFORJJHGVRWKDWWKHDLUÀRZFDQUHDFKHYHU\FRUQHURI
the room.
(3). /HDYHVHUYLFHVSDFHDURXQGWKHXQLWDVUHTXLUHGLQ)LJXUH
ƹ
Floor type
>600
>1000
>300
>600
>1500
ƹ
Ceiling type
>300
>600
>600
>1500
>200>2300
)LJXUH
(4). Install the unit where the drain pipe can be easily installed.
The space from the unit to the ceiling should be kept as much as possible so as for more convenient
service.
,QGRRU8QLW,QVWDOODWLRQ
(1). Determine the location of the hanger through the paper template, and then remove the paper template.
Paper template
Anchor bolt
)LJXUH
(2). Insert the anchor bolts into the drilled holes, and drive the pins completely into the anchor bolts with a
hammer.
(3). )LUVWO\XQ¿[WZREXFNOHVRQWKHJULOOHDVVKRZQRQWKHSLFWXUH5HPRYHWKHVFUHZVXQGHUWKHEXFNOHVE\
a screwdriver and then open the inlet grille.