Gree GFH09K3FI

108
U-Match Series DC
Inverter Service Manual
4 DISASSEMBLY AND ASSEMBLY PROCEDURE OF MAIN PARTS
4.1 Outdoor Unit
09/12K
Disassembly and Assembly of external casing
Remark :
Step Illustration Handling Instruction
1. Remove external casing
1. Remove the top cover and handle;
2. Remove the grille, outer case and right side plate.
2. Remove motor
1. Remove the blade nut and then remove the blade;
2. Remove the motor from motor support.
3. Remove compressor
1. Discharge the refrigerant inside the pipeline
and recycle the refrigerant during discharging;
2. Unsolder the 4-way valve assy from compressor;
5HPRYHWKHQXW¿[LQJFRPSUHVVRU
4. Take away the compressor from chassis.
4. Assemble compressor
1. Fix the new compressor on to the chassis;
2. Connect the suction port and discharge port
of compressor with the system pipes;
3. Properly connect the pwoer cord of compressor;
4. Renew the compressor electric heating
belt and discharge temperature sensor;
5. Check if the compressor rotates in reverse
and if the lubricant have leaked.
5. Assemble unit
Assemble the unit in the reverse
procedures of disassembly.